Universal Laser Systems Laser Platform M-300 Guía para resolver problemas descargar pdf (Pagina 99)

Operational

When printing to the laser system,

the computer gives an error

message “Printer out of paper” or

“Printer offline and not responding”

• Laser not powered on

• Laser System is running a file

• The print file is too large for memory

installed in laser system

• The Laser System has errors in the stored

print file

• Parallel port cable not connected or not

connected properly

• Bad parallel port in computer system

•

• Damaged port in CPU

• Turn on laser system

• Wait for the system to complete the file

• Reduce the physical size of the file or try to

print the file in sections

• Add more memory to the CPU

• Clear the computer’s print spooler, power

OFF then power ON the Laser System

• Connect cable or reseat connection at

computer and/or laser system

• Try printing to another printer using the same

port

•

Replace laser system’s CPU

Focus carriage looses X-axis

position and slams into the left or

right side of the rail during high

speed raster engraving

• Mechanical interference

• Dirty laser system

• CPU overheating

• Focus carriage X-axis bearing tensioning arm

too tight or binding

If the pattern is excessive:

• X-belt too tight

• Worn or binding X-axis bearings

• Worn or binding X-axis idler pulley

• Worn or binding X-axis motor

• Firmware needs updating

• Check if focus carriage makes contact with

material or other objects

• Clean all optics, rails, bearings and belts

• Clean CPU filters, correct ambient

temperature to be within specifications

• Remove carriage from rail, check for freedom

of movement of tensioning arm. Lubricate if

necessary. Position of tensioning arm should

be no greater than 10 o’clock.

• Check and/or adjust

• Check and/or replace

• Check and/or replace

• Check and/or replace

• Check with Service Department

When homing, the arm slams

repeatedly for a few seconds

• Bent Y-flag

• Dirty or faulty home sensor(s)

• Faulty flex cable

• Faulty lower flex cable board

• Check and/or straighten

• Try to clean sensor(s) with compressed air

• Replace upper flex board (home sensor)

• Replace flex cable

•

Replace Lower flex cable board

When focusing, the Z-axis table only

moves in one direction

• Dirty or faulty Z-axis sensor • Try to clean sensor(s) with compressed air,

otherwise replace sensor

When running the laser system, the

laser system will “freeze”, the clock

will keep advancing, but the

operator will have no control over

the system. The only way to restore

the system is to power the laser off

and then back on. This is a

symptom of file corruption.

• Incorrect BIOS setting in computer

• Bad printer cable

• Usage of device in between computer and

laser system

• Some other parallel port driver interfering

with the laser system printer driver

• Faulty printer port in computer

• Faulty internal ribbon cable

• Damaged port in CPU

• Refer to manual on proper setting

• Replace printer cable

• Connect the laser system directly from

computer with the printer cable

• Remove all other parallel port drivers and try

again

• Try printing from another computer

• Replace internal parallel cable

•

Replace laser system’s CPU

1 2 ... 94 95 96 97 98 99 100

Comentarios a estos manuales

Sin comentarios