Universal Laser Systems Laser Platform M-300 Guía para resolver problemas descargar pdf (Pagina 73)

7-12 Sample Materials

DELRIN (SEAL PRESS)

RASTER ENGRAVING

LASER WATTAGE POWER SPEED PPI PASS DEPTH

15 100 18 500 1 .015”

20 100 23 500 1 .015”

25 100 29 500 1 .015”

30 100 35 500 1 .015”

VECTOR CUTTING

LASER WATTAGE POWER SPEED PPI PASS DEPTH

15 75 1.2 200 1 .060”

20 75 1.6 200 1 .060”

25 75 2.0 200 1 .060”

30 75 2.4 200 1 .060”

COMMENTS

The laser system can be used to make dies

for seal presses. It can engrave and cut out

a typical Notary Seal in less than 5 minutes.

Create the male with a white graphic and a

black background. Mirror the image and

invert it by making the background white and

the graphic black. Add a .010 inch black

outline to the graphic portion of the female

side. This will give the greater clearance to

the female side to prevent the paper from

piercing through when the male side of the

seal presses into the female side. Once the seal is made and fastened to the press, make

several impressions onto 400 grit sandpaper to smoothen out the edges of the plastic. Make

sure you turn the sandpaper over to get both sides of the seal.

WARNING: LASER CUTTING THIS MATERIAL CAN CAUSE

FLAMING. Use caution when attempting to cut this material. Make sure

that the flame does not come in contact with any part of the laser system.

NEVER leave the machine unattended while processing any material.

Damages caused by processing any material WILL NOT be covered

under warranty.

MALE FEMALE

1 2 ... 68 69 70 71 72 73 74 75 76 77 78 ... 99 100

Sin comentarios

Universal Laser Systems Laser Platform M-300 Guía para resolver problemas Pagina 73