Universal Laser Systems Laser Platform M-300 Guía para resolver problemas descargar pdf (Pagina 13)

SECTION 2

Installation

Proper operating conditions are vital to a safe and productive environment. This section

describes the ideal environment and setup of the laser system. Failure to operate the laser

system within these guidelines can seriously damage the laser system and may cause an

unsafe operating environment. Although conforming to these guidelines will greatly reduce the

chance of a problem occurring, it does not guarantee it. It is your responsibility to provide a

safe and proper operating environment.

Operating Environment

• Ambient room temperature MUST be between 50 and 95 degrees F (10 and 35 degrees C).

The Laser Cartridge is equipped with a special temperature sensor that detects if the

ambient room temperature is not within specifications and will prevent the Laser

Cartridge from emitting a laser beam until proper room temperature is achieved.

• Ambient room dewpoint temperatures MUST be less than 50 degrees F (10 degrees C).

• The laser system MUST be installed in an office type environment. Dusty or dirty air

environments can damage the laser system. Keep the laser system isolated from any type

of sandblasting, sanding, grinding, milling, sawing, or any other machinery that produces

airborne particles or caustic fumes.

• The laser system MUST be installed in a properly ventilated room. Some materials, after

laser engraving or cutting, continue emitting fumes for several minutes after processing and

will contaminate the room if ventilation is not sufficient.

• Choose a location for the laser system where it provides the shortest and most direct path to

the exhaust ductwork. Refer to exhaust requirements later in this section.

• Provide a work table or storage area next to or nearby the laser system. This prevents the

operator from using the system as a table or storage facility.

Electrical Requirements

• Refer to the “INPUT POWER” sticker near the system’s ON/OFF switch and power inlet for

your system’s electrical requirements. Make sure that your electrical outlet is capable of

providing the proper voltage, frequency and amperage that your laser system needs.

• Noisy or unstable electricity as well as voltage spikes can cause interference and possible

damage to the electronics of the laser system. It may be necessary to connect the laser

system to a dedicated electrical line if this is a problem in your building.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 99 100

Sin comentarios

Universal Laser Systems Laser Platform M-300 Guía para resolver problemas Pagina 13