Universal Laser Systems Laser Platform M-300 Guía para resolver problemas descargar pdf (Pagina 58)

Maintenance 6-5

Tilt the front cover at enough angle so that you can apply the Lens Cleaning solution directly to

the #3 Mirror and to the Focus Lens. Flood the surfaces with the solution. If heavy debris is

present, let the solution soak in for a minute. Roll a fresh cotton swab across the #3 Mirror to

dry it off. Remember that it is okay if a small amount of lint from the cotton swab remains on the

mirror. Repeat this procedure for the Focus lens and always use a fresh swab.

Beam Window

The Beam Window is where the laser beam enters into the engraving area. It is located in the

upper left hand corner of the engraving area against the back wall and is yellow in color. It is

not necessary to remove the Beam Window for cleaning since it can only get dirty on the front

side. The backside is in a sealed environment. To clean the Beam Window, moisten a cotton

swab and gently roll it across. Basically, clean it in the same manner as the #2 Mirror.

Z-axis Table Removal

Power the system OFF. Loosen the large

thumbscrew in the lower left side of the table. Place

fingers into holes in table. Slide the table forward

until it stops, then lift up and out of the system.

To reinstall, flip the table over and take note of how

the table engages with the support brackets inside

the system. Place table right side up, install into

system by placing the table close to the front of the

machine and sliding the table toward the rear,

engaging the table with the support bracket. Tighten

the thumbscrew.

1 2 ... 53 54 55 56 57 58 59 60 61 62 63 ... 99 100

Sin comentarios

Universal Laser Systems Laser Platform M-300 Guía para resolver problemas Pagina 58