Universal Laser Systems Laser Platform M-300 Guía para resolver problemas descargar pdf (Pagina 54)

SECTION 6

Maintenance

Keeping the laser system clean will ensure the highest quality engraving. The frequency of

cleaning will depend entirely on the type of material being engraved, the performance of your

exhaust blower, the operating environment, and the amount of laser system usage over a given

period of time. Dirt or debris that is allowed to build up on the motion system components will

cause uneven or rough engraving, or loss of engraving position as well as premature

component failure. Smoke or dirt buildup on the optics can cause damage to them, loss of laser

power, or premature failure of these components. Use good judgment and keep in mind that a

clean machine is the best performing machine.

Always power the laser engraving system OFF and unplug it before performing

any cleaning procedures.

Suggested Cleaning and Maintenance Supplies

• Soap solution mixture of 1 tablespoon (2 cl) liquid soap and 1 quart (liter) of water in a spray

bottle

• Paper towels

• Cotton cloth

• Denatured alcohol (NOT to be used on any painted surface, plastic, or the Top Window)

• Acetone (can be used on the engraving table but nowhere else)

• Cotton swabs (supplied)

• Lens cleaner (supplied)

• Lens tissue (supplied)

• Vacuum cleaner

• Set of Allen wrenches sized from .050 to 3/16 inch

*NOTE: When using acetone or denatured alcohol, please follow the instructions on the printed

label of these materials for safe handling procedures.

Please familiarize yourself with the motion system components in the following diagram. It will

help you understand which components need periodic cleaning.

1 2 ... 49 50 51 52 53 54 55 56 57 58 59 ... 99 100

Sin comentarios

Universal Laser Systems Laser Platform M-300 Guía para resolver problemas Pagina 54