Universal Laser Systems Laser Platform M-300 Guía para resolver problemas descargar pdf (Pagina 14)

2-2 Installation

• If electrical power fluctuations, brown outs, or constant power outages are a problem in your

area, an electrical line stabilizer, UPS (Uninterruptible Power Supply), or backup generator

might be required. If installing any of these devices, make sure that they meet the electrical

requirements of the laser system.

• Never remove the ground lead to the electrical cord and plug the system into a non-

grounded outlet. This is very dangerous and can lead to a severe, if not fatal, electrical

shock. Always plug the system into a 3 prong grounded outlet.

• Do not operate the laser system near devices that give off high levels of radio

frequency (RF) emission. High levels of RF will interfere with the operation of the laser

system and can damage your system or seriously effect your engraving or cutting quality.

If the above requirements cannot be met, you may need the services of a qualified, licensed

electrical contractor to certify your installation. Remember, it is your responsibility to provide a

quality electrical source. Damages to the laser system due to neglect, abuse, or improper

or unsuitable electrical supply will not be covered under warranty.

Exhaust Requirements

• The exhaust blower MUST be mounted on the OUTSIDE of the building either on the roof or

on a cement pad next to the building. It may be necessary to mount the blower on vibration

dampers.

• The exhaust system MUST be capable of supplying a minimum of 150 CFM (cubic feet per

minute) @ 6 inches of static pressure (water). In order to meet the laser system’s CFM

requirements, a high-pressure, high static pressure rated, exhaust blower must be installed.

This type of blower has self-cleaning blades and can maintain airflow even though

restrictions are introduced. Length of exhaust pipe, exhaust pipe diameter, number of 90-

degree angles, and other restrictions must be calculated when determining the correct

exhaust blower unit. Installing an incorrect or undersized blower is not only unsafe, but it can

also lead to premature and excessive wear and tear to the laser system. We recommend

that you hire a certified and licensed contractor to design and install your exhaust system.

DO NOT install forward incline, backward incline, in-line, or ventilator fans because

these types of air handlers are inadequate and inappropriate for this type of

installation. If your contractor has any questions concerning blower specifications or

exhaust system requirements, please contact our Service Department directly before

installation.

• Rigid tubing should be used for 90% of the distance traveled. The tubing should be smooth

and have as few 90 degree bends as possible. Use tubing with a diameter that matches the

inlet of the exhaust blower. When with tubing is within 5 feet of the laser system, attach a

airflow gate, and then use a reducer to couple the tubing down to 2.5 inches (635 mm).

NEVER connect rigid tubing directly to the laser system. Use a short piece, 2 to 5 feet

(excessive length reduces airflow) of industrial grade wire reinforced rubber tubing, to

connect to the laser system. This will provide laser system mobility and will dampen

vibrations coming from the blower.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 99 100

Sin comentarios

Universal Laser Systems Laser Platform M-300 Guía para resolver problemas Pagina 14