Universal Laser Systems Laser Platform M-300 Guía para resolver problemas descargar pdf (Pagina 61)

6-8 Maintenance

Maintenance Schedule

Since the maintenance requirements of the laser system is dependent on the type of material

being run, the quantity of material being removed, the hours of operation, and the quality of the

exhaust blower, it must be user defined.

As a starting point, we recommend the following schedule:

• As necessary

Engraving Table

Main enclosure

Top Door Window

• Every 8 hours of engraving

Clean X-axis and Y-axis Bearings

Clean X-axis and Y-axis Rails

Clean X-axis Belt

Check Beam Window, #2 Mirror, #3 Mirror, and Focus Lens for contamination. Clean

ONLY if dirty.

• Every month

Clean Cooling Fan filters

Clean and re-lubricate Z-axis Lead screws

Check for X-axis and Y-axis Belt wear – replace as necessary

Check and/or clean X-axis and Y-axis Drive Gears

Check for X-axis and Y-axis Bearing wear – replace as necessary

Inspect system for loose screws and mechanical parts – tighten if necessary

• Every 6 months

Exhaust Plenum

If you are noticing a considerable buildup of debris on the optics and the motion system, clean

the system at more frequent intervals. If your system has remained relatively clean, you can

extend your cleaning intervals. You need to be the judge but keep in mind that a clean machine

is a better performing machine and can extend the life of the parts as well as reduce the

possibility of down time. If you have any questions about maintaining the laser system, please

contact our Service Department.

1 2 ... 56 57 58 59 60 61 62 63 64 65 66 ... 99 100

Sin comentarios

Universal Laser Systems Laser Platform M-300 Guía para resolver problemas Pagina 61