Universal Laser Systems Laser Platform M-300 Guía para resolver problemas descargar pdf (Pagina 62)

SECTION 7

Material Applications

Guide

This section provides sample driver settings and helpful hints to get started engraving and/or

cutting the materials listed.

Safety

• NEVER LEAVE THE LASER SYSTEM RUNNING UNATTENDED FOR ANY REASON.

Exposure to the laser beam can cause ignition of combustible materials. All laser cutting

and engraving should be constantly supervised.

• NEVER OPERATE THE LASER SYSTEM WITHOUT A PROPERLY INSTALLED AND

OPERATING EXHAUST SYSTEM. Some materials when cut or engraved can produce

fumes that are hazardous in concentrated amounts. Also make sure that your room is

adequately ventilated as some materials will continue to produce fumes for several minutes

to possibly hours after the cutting or engraving process has been completed. Since many

materials can produce toxic and possibly caustic fumes or residue, it is advisable to obtain

the Material Safety Data Sheet (MSDS) from the materials manufacturer. The MSDS

discloses all of the hazards when handling or processing that material. The law requires all

manufacturers to provide this information to anyone who requests it.

• DO NOT ENGRAVE OR CUT PVC (Polyvinylchloride) BASED MATERIALS. The fumes

are extremely toxic if you inhale them. The fumes are so caustic that it can chemically

destroy the metal parts of the laser system. Damage to the laser system from this type of

abuse WILL NOT be covered under warranty.

• DO NOT ENGRAVE OR CUT UNCOATED METALS OR REFLECTIVE SURFACES. The

laser beam can reflect off of these materials causing damage to the laser system as well as

being a safety hazard. Damage to the laser system from this type of abuse WILL NOT be

covered under warranty.

1 2 ... 57 58 59 60 61 62 63 64 65 66 67 ... 99 100

Sin comentarios

Universal Laser Systems Laser Platform M-300 Guía para resolver problemas Pagina 62