Universal Laser Systems Laser Platform M-300 Guía para resolver problemas descargar pdf (Pagina 18)

2-6 Installation

Slowly rotate the Laser Cartridge making sure that the Alignment Plate is centered in the small

gap of the Alignment Fork. Keep rotating the laser until the Laser Latch “clicks” and locks the

cartridge into place. Make sure that you do not pinch any wires during this process. It

may require some slight force to actuate the latch.

• Verify that the cartridge is resting, at a 90-degree angle, and the Alignment Plate is centered

within the Alignment Fork.

• Plug in the Power Connector. The connector is keyed so it will only insert one way.

• Close the Rear Cover and push down on the latches until they “click”. Later in this section,

we will verify that you have installed the cartridge correctly. For now, we will assume that it

is OK and move on to the next section.

• Open the Top Door of the laser system. Remove any packing material from within the

engraving area. Remove the rubber band that retains the X-axis arm.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 99 100

Sin comentarios

Universal Laser Systems Laser Platform M-300 Guía para resolver problemas Pagina 18