Universal Laser Systems Laser Platform M-300 Guía para resolver problemas descargar pdf (Pagina 22)

3-2 System Operation

Once a file is sent from the computer, the CPU stores this file in its memory until either a new

file is sent (printed) to it, the system gets re-homed which clears it’s memory, or the system is

powered OFF. Located on the CPU are standard, computer memory SIMM(s) (30 pin, non-

parity, 70 ns) that store the print file as long as the system remains powered ON. Once the laser

system receives a print file, that particular file can be repeated as many times as desired.

Once the “START” button is pressed the CPU starts the Motion System movement which places

the Focus Carriage (part of the motion system that contains the Focus Lens) above the

designated engraving or cutting area. The CPU then sends signals to the Laser Cartridge to

precisely control the firing of the laser beam with the movement of the motion system. Once the

file is complete, the Focus Carriage will go “home” to the upper right corner.

The laser system is shipped with a standard 4 MB SIMM. Although it is unlikely that a single file

can exceed the memory capacity, it is possible if the file fills the entire engraving area, has a

large amount of fine detail, and engraved at the highest resolution of 1000 DPI. The system can

also run out of memory if the entire engraving area is engraved using the “3D” effects in the

Printer Driver. If necessary, additional memory can be purchased from your Dealer or directly

from our Customer Support Department.

The programming code that operates the CPU Module is called the “Firmware”. At some point

in time, ULS may update the Firmware code due to product enhancements, software

compatibility, bug fixes, etc. Firmware updates are available through your dealer or directly from

our Customer Support Department’s web-based email system at (www.ulsinc.com

5) Control Panel

This is where the operator controls the laser

system.

START: Providing that there is a file in

memory, pressing the START button will begin

laser processing from the beginning of the file. After the file has completed processing,

pressing START again will process the file again from the beginning. You can repeat the file as

many times as you wish providing you do not send a new file nor power the system OFF.

STOP: Will halt the engraving or cutting process. If you sent a new file while the system was

running the previous file, pressing STOP will not only halt the engraving or cutting process, but

it will also clear the existing file from memory and allow the new file to take it’s place.

NOTE

We suggest that you do not “Print” another file while one is processing. If you do, your

computer will respond, “There is an error printing to LPT?. The Printer is not ready. Make sure it

is turned on and online. Select Retry or Cancel”. If you select Retry, you will keep getting this

message until the laser system completes it’s file in memory or you press the Stop button.

DOWN: Will move the Z-axis table down .01 inch. If you press and hold the button, the Z-axis

table will continue to move slowly in .01 inch increments until it has moved ½ inch and then it

will automatically increase speed until you release the button and start the process over again.

UPDOWNSTOPSTART

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 99 100

Sin comentarios

Universal Laser Systems Laser Platform M-300 Guía para resolver problemas Pagina 22