Universal Laser Systems Laser Platform M-300 Guía para resolver problemas descargar pdf (Pagina 64)

Sample Materials 7-3

When engraving very small objects, top speed cannot be achieved because acceleration and

deceleration of the motion system requires time and distance. The laser system will

automatically adjust itself to a maximum engraving speed that it can achieve due to the size and

position of the graphic. This is why you might notice that there might be no difference in

engraving time on certain graphics whether you choose 100% speed or less.

The following materials were tested with the laser system set at 500 DPI except where noted

otherwise. The following pages will fully describe the results of these tests and will offer helpful

hints when choosing materials, setting parameters, and using different techniques to provide the

best laser cutting and engraving results.

USE THESE SETTINGS AS A GUIDELINE OR STARTING

POINT ONLY. Since many factors can affect engraving or

cutting depth as well as engraving quality, it is most likely that

these settings will need to be adjusted to produce desirable

results.

ACRYLIC - CAST AND EXTRUDED

ACRYLIC – MIRRORED

ALUMINUM – ANODIZED

BRASS – PAINTED

CORK

CORIAN / AVONITE / FOUNTAINHEAD

DELRIN (SEAL PRESS)

GLASS / CRYSTAL

LEATHER

MARBLE

MAT BOARD

MELAMINE

PLASTIC – MICROSURFACED

RUBBER STAMPS

VINYL – SIGN (3 MIL)

WOOD / WOOD INLAY

1 2 ... 59 60 61 62 63 64 65 66 67 68 69 ... 99 100

Sin comentarios

Universal Laser Systems Laser Platform M-300 Guía para resolver problemas Pagina 64