Universal Laser Systems X-600 Guía para resolver problemas descargar pdf (Pagina 46)

Section 4-1

Section 4

Basic Maintenance

Keeping the laser system clean will ensure the highest quality engraving. The frequency of cleaning will

depend entirely on the type of material being engraved, the performance of your exhaust system, the

operating environment, and the amount of laser system usage over a given period of time. Dirt or debris

that is allowed to build up on the motion system components will cause uneven or rough engraving, or

loss of engraving position as well as premature component failure. Smoke or dirt buildup on the optics

can cause damage to them, loss of laser power, or premature failure of these components. Use good

judgment and keep in mind that a clean machine is the best performing machine. Always turn the laser

engraving system OFF and unplug it before performing any cleaning procedures.

Cleaning and Maintenance Supplies

• Soap solution mixture of 1 tablespoon (2 cl) liquid soap and 1 quart (liter) of water in a spray bottle

• Paper towels

• Cotton cloth

• Denatured alcohol (NOT to be used on any painted or plastic surface)

• Acetone (can be used on the engraving table but nowhere else)

CAUTION

When using acetone or denatured alcohol, please follow the instructions on the printed label of

these materials for safe handling procedures.

• Cotton swabs (supplied)

• Lens cleaner (supplied)

• Vacuum cleaner

• Set of Allen wrenches sized from .050 to 3/16 inch

System Cleaning and Maintenance

Motion System

• Turn off and unplug the laser system.

• Open the top door and thoroughly remove all loose dirt and debris from inside the machine with a

vacuum cleaner.

• Clean the engraving table surface with either a soap solution, or alcohol or acetone, and paper

towels. NEVER pour or spray any solution directly into the laser system. Always dampen your paper

towel or cloth outside of the machine with the cleaning solution and then wipe down the parts you are

cleaning with the dampened cloth.

• Clean X-rail and the Y-rails by using either the cotton swabs or paper towels, and alcohol or soap

solution. Pay close attention to the bearing tracks since any debris left to build up in these bearing

tracks will cause the bearings to wear and the engraving quality to become rough.

• After the rails and tracks are cleaned, use a clean swab or paper towel, and alcohol to clean all of the

bearings by holding the swab against each bearing and moving the motion system by hand to roll the

bearings against the swab. There are seven bearings in the system, three (3) on the focus carriage,

two (2) on the left side of the X-rail, and two (2) on the right side of the X-rail.

• Clean the top window with a cotton cloth and the soap solution or window cleaner.

• Use a soft cloth or paper towels and the soap solution to clean the enclosure. DO NOT use alcohol,

acetone, or any other harsh chemical, as this will damage the paint.

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 73 74

Comentarios a estos manuales

Sin comentarios

Universal Laser Systems X-600 Guía para resolver problemas Pagina 46

Comentarios a estos manuales

Relacionado con productos y manuales para Grabador Universal Laser Systems X-600