Universal Laser Systems X-600 Guía para resolver problemas descargar pdf (Pagina 17)

INSTALLATION

Section 2-5

Computer and Operating System

Minimum Computer Requirement

• Windows XP Home or Professional Edition computer. Macintosh computers are not compatible

• 1.5GHz processor with 256 MB RAM and a 40 GB hard drive

• Writable CDROM drive

• Monitor (minimum 800 x 600 resolution)

• Mouse or other pointing device

• Ethernet port 10/100 Ethernet connection

• Ethernet hub or Ethernet switch (see below)

• Internet connection and email address (not required, but recommended)

If the external computer is part of a network, the Laser System’s Ethernet cable can be connected directly

to a computer network. However, in the case of a stand-alone external computer, a hub or switch is

required between the computer and the laser system.

Printer Driver Installation

• Do not connect an Ethernet cable to or power on the laser system at this time otherwise

unexpected results will occur.

• Attached to the inside rear cover of this manual you will find a CD-ROM that contains the XL

Series Print Driver and Firmware. Place this CD into your computer’s CD-ROM drive.

• Using Windows Explorer, locate and double click on file xlinst.exe

• The installation software will execute and the ULS Network Printer Installation dialog box will

appear. Remove the checkmark in the “Install Printer Firmware” checkbox so that ONLY “Install

Printer Driver” is checked and click Next.

• Select which XL Series Model Printer you wish to install and then click Next.

• You will be prompted to enter the network address for your printer. Choose between DHCP

(Server Assigned IP Address) and IP Address (manually assigned IP Address). If you do not

know which one to choose, contact your network specialist.

• If choosing DHCP, choose a network ID from the dropdown list and then click Next. However, if

choosing an IP Address, select IP Address, enter a Printer IP Address, and then click Next.

• The printer driver files will now be copied to your computer’s hard drive. Once it finishes, click the

Finish button to complete the installation.

Recommended Software Programs

The following is a list of recommended software programs.

• CorelDraw 12 or X3

• AutoCAD 2000i or higher

• Adobe Photoshop (for photo editing)

**Most users purchase the CorelDRAW12 Graphics Suite package which contains all the software

necessary to operate the laser system to its fullest capability. Earlier versions of CorelDRAW

have experienced problems with the XP operating system, which in turn, causes problems with

the operation of the laser system. As a result ULS recommends CorelDRAW12 over earlier

versions. Whether you decide to use CorelDRAW12 or a different graphics software package, it is

critical that you fully understand how to use the software in order to successfully operate the

laser system. While ULS has made reasonable efforts to make the laser system as compatible as

possible with graphics and CAD software written for the Windows XP operating systems, ULS

cannot guarantee complete compatibility with any software not manufactured by ULS.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 73 74

Comentarios a estos manuales

Sin comentarios

Universal Laser Systems X-600 Guía para resolver problemas Pagina 17

Comentarios a estos manuales

Relacionado con productos y manuales para Grabador Universal Laser Systems X-600