Universal Laser Systems X-600 Guía para resolver problemas descargar pdf (Pagina 14)

INSTALLATION

Section 2-2

• Level the feet by placing a bubble

level across the top of the legs at

position 1 and 2. Using a wrench,

adjust the feet until the bubble is level.

Do the same across the top of the

rear legs at position 3 and 4. DO

NOT adjust the legs between

positions 3 and 1 and between

positions 2 and 4. This adjustment

has been pre-set at the factory and

further adjustment may twist the body

of the system.

DO NOT REPLACE THE LEVELING FEET WITH CASTERS. THE LEVELING FEET

PROVIDE A STURDY SUPPORT FOR THE SYSTEM WHILE IT IS OPERATING. THE

ADDITION OF CASTERS WILL CAUSE ENGRAVING AND/OR CUTTING QUALITY

PROBLEMS.

System Installation

• Open the top door and remove any tie-downs, straps, or any packing materials that is holding the arm

in place.

• Remove any remaining packing materials, accessories or any other items that may be located inside

the cabinet or on top of the engraving table.

Laser Cartridge Installation

Before connecting and powering on your system, you must install the laser cartridge(s).

Make sure that your power cord IS NOT plugged

in at this time. Press on the backside of the two

hinges (1) (the other one is not shown), on the

top of the rear cover to release the latch. Gently

fold back the rear cover.

Visually locate the mounting blocks (1), the laser

latches (2), bottom laser plug (3), gasket (4),

and the alignment forks (5 & 6). Notice that the

alignment fork has two plates, one small (5) and

one large (6). Locate the gap between the two

plates (5&6).

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 73 74

Sin comentarios

Universal Laser Systems X-600 Guía para resolver problemas Pagina 14