Universal Laser Systems X-600 Guía para resolver problemas descargar pdf (Pagina 25)

INSTALLATION

Section 2-13

Postscript (PS) Images

The laser system is NOT a postscript device. This means that postscript fills, postscript textures, and

especially POSTSCRIPT FONTS WILL NOT be able to print to the laser system. Sometimes using

Adobe Type Manager (ATM) will allow some postscript fonts to print correctly but most of the time does

not work properly.

Helpful Tip

If you are having any problems printing a font and you cannot figure out what is going on, select the font

and “convert to curves” or “convert to paths” in your graphics software. This will convert the font into a

bitmapped image and will print correctly to the laser system. Refer to your graphics software on how to

convert fonts. However, postscript textures and postscript fills cannot be converted and will not print to

the laser system.

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 73 74

Sin comentarios

Universal Laser Systems X-600 Guía para resolver problemas Pagina 25