
OPERATION AND PRINTER DRIVER CONTROLS
Section 3-4
Air/ Gas Flow
The air or gas flow rate can be set from 10% to 100%, in 10% increments.
Image
The Image Density set in the print driver is displayed, but cannot be edited.
Which Laser
Both / Top / Bottom
Red Dot Pointer
On / Off
Delete This File
Yes / No, used to delete selected file.
System Options Menu
About
SW: Software Version Vx.xx
FW: Firmware Version Vx.xx
HW: Hardware Version Vx.xx
Language
English
Espanol
Francais
Deutsch
Italiano
Units
Inches
Metric
Connection
IP: Fixed IP Address Input.
DHCP: Network Assigned IP Address.
Auto Z
On / Off: Allows Z height to be programmed in the printer driver.
1. Enable the Z Axis in the printer driver.
2. Using the slide scale in the printer driver set material thickness.
3. Press set in the printer driver.
4. Table will lower to the edited Z height before mark starts.
Red Dot Pointer
On / Off: This option is used for test marking, when active the diode pointer is on, laser beam will not be
emitted. All doors must be closed before motion will move.
Lens Type
Not selectable, all lens types are detected automatically; all must be calibrated in the Set Lens Focus
section of the System Options Menu.
Comentarios a estos manuales