Universal Laser Systems X-600 Guía para resolver problemas descargar pdf (Pagina 13)

Section 2-1

Section 2

System Installation

The following operational guidelines are vital to a safe and productive environment. It is your

responsibility to provide a proper operating environment.

Damage to the laser system due to an inadequate or improper operating

environment is considered abuse and WILL NOT be covered under warranty. In no

event will ULS be liable for any damages caused, in whole or in part, by customer,

or for any economic loss, physical injury, lost revenue, lost profits, lost savings or

other indirect, incidental, special or consequential damages incurred by any

person, even if ULS has been advised of the possibility of such damages or claims.

Facility

• The device MUST be installed in an office-type or light duty manufacturing environment. Airborne

pollutants can damage the device. Keep the device isolated from any sandblasting, sanding or

machining equipment or any other machinery that produces airborne particles. Also, do not

operate or store this device near sources of water, saltwater, or oil vapor.

• For best results, we recommend operating this air-cooled device in the ambient temperature

range of 73ºF (22ºC) to 77ºF (25º C). It may operate, however, in certain conditions if the

ambient temperature is between the range of 50ºF (10ºC) to 95ºF (35º C).

• Avoid storing the device outside the temperature range of 50ºF (10ºC) to 95ºF (35º C) as

excessively cold or hot temperatures can damage the laser cartridge or reduce its lifetime.

• Ambient humidity levels must be non-condensing.

• The facility must be able to accommodate receiving the system, fully assembled. The system

CANNOT be disassembled nor turned on its side to facilitate the placement of the system in a

particular location. The system dimensions can be found in the specifications section in the

beginning of this manual.

• Choose a location for your laser system where you will be routing your exhaust system piping,

your electrical power supply, and your computer system.

• The laser system MUST be placed on a firm, hard surface. Concrete or hard tile is recommended.

DO NOT place on an unsupported floor that may sag. From the weight of the machine.

• For servicing reasons, make sure that the system is located in a place where it can reside at least

2 feet from the wall and 2 feet from any obstruction to the left and right sides of the machine. The

rear as well as the side panels must have enough room to fold downwards for service.

ONCE THE SYSTEM IS LOCATED IN ITS FINAL RESTING POSITION, IT IS CRITICAL

THAT THE SYSTEM IS LEVELED USING THE FOLLOWING PROCEDURE. DO NOT

USE ANY OTHER METHOD OF LEVELING. AN IMPROPERLY LEVELED MACHINE

WILL HAVE LASER BEAM ALIGNMENT AND ACCURACY PROBLEMS.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 73 74

Sin comentarios

Universal Laser Systems X-600 Guía para resolver problemas Pagina 13