Universal Laser Systems X-600 Guía para resolver problemas descargar pdf (Pagina 30)

OPERATION AND PRINTER DRIVER CONTROLS

Section 3-5

Cutting Table (Optional)

Installed Yes / No: Used for calibration of an optional cutting table.

1. Home Z axis.

2. Press

to enter the motion menu.

3. Press

again until Z axis is highlighted.

4. Press

to accept.

5. SYSTEMS OPTIONS MENU will appear.

6. Scroll down to the CUTTING TABLE INSTALLED.

7. Press

to enter.

8. Press

again to toggle CUTTING TABLE INSTALLED.

9. Press

to accept.

10. Press the DOWN SCROLL ARROW

too choose CALIBRATE.

11. Press

to open CALIBRATE MENU, using the focus tool, focus to the top of the cutting table by

pressing either the up or down arrow

12. Press

, you will be prompted to save new Z position, choose yes or no.

13. You have now completed focus to the CUTTING TABLE.

Traveling Exhaust (Optional)

On / Off: Activates optional traveling exhaust blower.

Tuning

Used for raster engraving only. Shifts right to left and left to right raster lines for better quality engraving.

Set automatically through print driver or manually at display.

Alignment Mode

Used for performing beam alignment and to test for max power.

1. Remove the lens kit from the focus carriage by removing thumb screws.

2. Using masking tape, tape over the beam entrance hole on left side of carriage.

3. Press

then to access the System Options Menu.

4. Scroll down to Alignment Mode, press

to select.

5. A screen will appear with defaults of 5% power and 2 KHz and Both for laser option.

6. If changes need to be made to the default settings, press

to edit, then using the arrow keys

select which setting you wish to edit. Press

to confirm.

7. Press

to return to the previous window.

8. Using the arrow keys

, move the carriage to the upper left corner.

9. Press

to fire the laser, press again to stop firing the laser. Fire the laser only long enough to

discolor the tape.

10. Using the arrow keys

, move the carriage to the lower right corner.

11. Press

to fire the laser, press again to stop firing the laser. Fire the laser only long enough to

discolor the tape.

12. Both burns should be overlapping and in the center of the tape.

13. If not, make adjustment to the #2 mirror assembly until 2nd burn covers the 1

14. Press

to quit. Motion will return home.

Print Job Cache

System will store up to 100 jobs.

Jobs downloaded to system are permanently stored on the internal hard drive; jobs can be accessed from

the main screen (job preview screen).

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 73 74

Comentarios a estos manuales

Sin comentarios

Universal Laser Systems X-600 Guía para resolver problemas Pagina 30

Comentarios a estos manuales

Relacionado con productos y manuales para Grabador Universal Laser Systems X-600