Universal Laser Systems Laser Platform M-300 Guía de usuario descargar pdf (Pagina 46)

7. Once you have the new engraving field size, exit the printer driver properties dialog.

8. In your graphics software change the page size to equal the new engraving field size from the printer

driver dialog.

9. This new vertical dimension of the page is now the circumference of the material to be engraved.

10. Position your graphic on page so that it is located horizontally within the upper and lower engraving limits

that you determined earlier and center the graphic vertically as shown below.

11. Once you are ready to print, select print in your graphics software and check to make sure rotary mode is

still enabled and the correct diameter for your material is still entered in the printer driver dialog.

12. Then set the appropriate power and speed settings before printing the job.

Note: Remember, before running a rotary job, to rotate the material by hand until the position you want to

be the center of your graphic is facing directly up. Keep in mind that the rotary fixture does not have a

home location in the rotational axis so the top most part of the material (the part facing straight up) is

always the center of the graphic when printing using the materials driver tab or the center of the page

when printing using the manual driver tab.

Printer Driver Settings (materials driver tab)

1. Start the graphic software you plan to print the job from and open or create the artwork you plan to print to

the laser system.

2. Position your graphic on page so that it is located horizontally within the upper and lower engraving limits

that you determined earlier and center the graphic vertically as shown below.

106

1 2 ... 41 42 43 44 45 46 47

Sin comentarios

Universal Laser Systems Laser Platform M-300 Guía de usuario Pagina 46