Universal Laser Systems Laser Platform M-300 Guía de usuario descargar pdf (Pagina 41)

Rotary Fixture

The Rotary Fixture allows the laser system to engrave and mark on

cylindrical objects. The Rotary fixture is equipped with an external cone

shaped fixture mounted to the fixed, motorized end and an internal cone

shaped fixture attached to the adjustable end allowing the fixture to hold a

variety of objects such as wine glasses, mugs, cups, etc. Additional

internal and external cone fixtures can be purchased by contacting the

ULS Customer Service Team at 480-609-0297 (USA), +43 1 402 22 50

(Austria), +81 (45) 224-2270 (Japan) or e-mail us at [email protected].

Installation

1. Lower the laser system engraving table enough to install the rotary fixture. Make sure the motion system

will clear the top of the rotary fixture.

2. Now turn the laser system OFF.

3. Place the rotary fixture support bracket (1) on the table positioned over the mounting holes on the right

side of the table. Install the provided thumbscrews, but leave the thumbscrews loose enough to allow

adjustment of the rotary fixture.

4. Place the Rotary Fixture on top of the bracket so that its pivot bolts sit in the forks in the mounting

bracket. Push the fixture (4) against the top ruler then tighten down the thumbscrews (5).

101

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 47

Sin comentarios

Universal Laser Systems Laser Platform M-300 Guía de usuario Pagina 41